Ghost 2 Immobiliser Problems

The Ghost 2 immobiliser, designed to guard cars against key cloning or hacking, is a discrete device that can be installed without causing damage to your vehicle. It stops your vehicle from starting unless you enter the correct sequence of buttons inside your vehicle like the password you enter on mobile phones.

Stop/Start

Ghost Immobilisers prevent vehicles from being stolen by preventing the engine from starting unless it receives the correct PIN code. This is accomplished without any modifications to the vehicle, and is completely undetectable to thieves. The unit communicates with the ECU on the CAN data bus, which allows it to lock the vehicle. This is the same system the one used by car makers for years. However, thieves are unable to overcome it using a brand new key, or key relay technology, like they could with factory fitted systems.

Ghost Ghost can be fitted to any car, van motorhome, caravan, or bike with an engine. It's compatible with all major brands of vehicles. The same system can also be used on electric vehicles. It's a great alternative to wheel clamps and steering wheel locks.

When the Ghost is activated, it will stop all buttons in your car, preventing the ignition being started without a PIN code. This can be done using the Android or Apple mobile apps or by entering the code via your key fob. If the wrong code is entered, the app will display an indicator light and the Ghost will not allow the vehicle to start again. This is a great method to deter thieves. If the vehicle can't be started the thieves will be able to move on.

The Ghost is a small, weatherproof device that is able to be hidden behind the most difficult-to-access areas of your vehicle. Installation takes between 20-30 minutes for each vehicle. It is also very simple to remove should you decide to switch your vehicle or return it for service or valet parking. It is a TASSA (Tracking and Aftermarket Security Systems Association) an insurance-approved system, and is recognized by a few insurance companies. It also comes with an emergency Pin Code override and features the Service/Valet Mode which can be activated with the application's button or with your key fob.

Disarm

In contrast to the mechanical anti-theft devices, which can be removed, ghost immobilisers are hidden and are integrated into the car. Even if they were to be found and stolen, thieves would not be able to start the car. They are almost impossible to bypass or hack. This is because ghost immobilisers (visit here) prevent key blocking, signal jamming, and device spoofing - techniques that are used frequently by thieves to get into vehicles that have standard immobilisers.

An immobiliser operates by sending an instruction to the ECU (electronic control unit). If a incorrect code is received and the vehicle does not start as the engine won't start. It is possible to disable a ghost immobiliser and tracker immobiliser with a software tool, but it's extremely difficult and time-consuming to accomplish this. The software can only be installed and operated by a authorised installer.

The Ghost immobiliser is a tiny system that sits within the vehicles wiring loom and is invisible to the naked eye once installed. It is not visible on diagnostic systems, there aren't LED indicators and it will not communicate with the engine through the OBD port. It communicates in silence through the CAN data loop.

The system won't allow the vehicle to start until it is provided with an input PIN number that is specified by the user. This is entered through buttons on the steering wheel, door panels or centre console. This is a more secure way to protect your car since it doesn't require the use of a key fob or remote control.

In addition to this Ghost offers the option of a service mode that can be activated using the application on your mobile phone. This will allow you to hand over your keys to someone for service or valet parking without entering the disarm sequence.

You should not remove the system from your Ghost yourself, regardless of whether it is in service mode. This could damage the engine. It is recommended to speak with a TASSA certified installer who can remove the system in a safe and secure manner. Our newest GHOST immobilisers have a specific fingerprint QR sticker that is hidden in various areas of your vehicle. They are linked to our security register. In the event that the device is removed and then sold on the blackmarket this will allow you to trace the original owner.

Anti-Hijack

Ghost Immobiliser 2 has a highly effective anti-hijack function. This is a sophisticated key that protects your car from thieves. Whenever the ignition switch is switched to on and the vehicle remains stationary for a period of 30 seconds and the Ghost system will stop the engine and turn the warning lights on. This gives the driver or passengers enough time to press a secret security button (depending on the vehicle) before the system is activated and the engine is again allowed to start.

The Ghost system, unlike many competitors, has a timer and controller unit which shuts down the fuel shut-off valve 14 after a set period of time. This happens regardless of whether the ignition is on. The delay time frame must be sufficiently long to allow the hijacked owner of the vehicle to drive away from the location of the hijacking and Ghost immobilisers a sufficient distance from the stalled vehicle before the system can be activated.

In addition to the standard CANbus immobiliser blocking capabilities of the ghost immobiliser car, it has an additional security level that blocks common methods of hacking that are used to hack into modern vehicles, such as relay attacks key range extending, key range hacking and ECU swapping. The Ghost system communicates in a silent manner and does not emit signals that can be detected by thieves with RF scanning or code-grabbing technology.

The Ghost system also comes with the Service/Valet mode that allows your vehicle to be temporarily re-started and driven without the need for ghost immobilisers an PIN code. This is a great option if you park your car and only need to leave it for a brief time, such as to open the garage door or place groceries in the boot. The system will end service mode according to speed and duration or via the simple PIN code entry process and give you peace of mind that only YOU can utilize your vehicle!

Keyless Entry

With the rise of car thefts that are not involving contact numerous customers are seeking out additional security options. This is particularly relevant for those who have invested time and money in customizing their car or own expensive automobiles. A supplementary immobiliser is a cost-effective way to prevent this kind of theft since it can prevent your vehicle from starting unless the right pin code is entered on your key fob.

Immobilisers are designed to impede various vehicle circuits, including ones that control the starter motor and the fuel pump. They can also disable the car alarm to attract attention and deter potential thieves.

These devices are directly connected to the engine control unit through the CAN data network and hinder thieves from gaining access to it by installing a new ECU or using key programmers. These immobilisers are installed in a discreet manner inside your vehicle, leaving no trace and are totally undetectable by the tools that hi-tech thieves use.

As opposed to other systems that require a particular application, or a tag that is worn on the person of the driver the Ghost immobiliser can only be deactivated by pressing a sequence of electronic buttons that are already present on your steering wheel, door panel, and central console, allowing you to choose a custom pin sequence. The pin can be changed as frequently as you want, which means it's as secure as a credit card. It can be even more difficult to crack because it requires up to 20 press.

Ghost also has a Valet/Service mode that allows users to deactivate it when you are going to give your vehicle for valet parking, or service. This allows the system to function within certain parameters such as a 30 mph speed limit. The system can be reactivated using the original key or corresponding entry code.

This makes it the most efficient and secure aftermarket CAN immobiliser on the market, and is insurance approved by Thatcham as an add-on for your car when installed by one of our certified installers. The Ghost 2 immobiliser is also supplied with six QR fingerprint labels as well as an ISR contact card that contains your unique QR code, as well as an emergency code that is secure that can be kept in the purse or wallet of your vehicle.